JRC JLN-900 Installation And Instruction Manual page 224

C4 TRU CALIBRAT.
MARKING: TC+123
The transducer (TRU) calibration is set with menu C4. Use – or + keys to
adjust the TC value to correspond to the engraved marking on the transducer
housing or cable #1 and then press Enter to save. Example TC+123 means
calibration factor +1.23%, TC–101 means calibration factor –1.01%.
4.4.5 Menu M, Miscellaneous
This menu contains miscellaneous settings and information about the system. To be able to
make changes to sub menus write access must be activated (changed to ON) before menu is
entered.
M0 MISCELLANEOUS
WRITE ACCESS OFF
M2 RESET CPU
DISABLED
Menu M2 restarts the system. Menu system will be closed and must be re-
entered.
Use + to enable the menu and then Enter to restart.
M4 TOT. DISTANCE
DIST=12345.30 NM
Menu M4 can be used to adjust the total distance counter.
Use – and + to change the value and then Enter to save.
NOTE: the distance counter values are sent as $VDVLW messages on the
serial output.
M5 TRIP DISTANCE
DIST=45.30 NM
The trip distance counter is reset with this menu.
Reset value by pressing Enter.
NOTE: the distance counter values are sent as $VDVLW message on the
serial output.
M6 SW REVISION
5400130 A01
Menu M6 shows the revision of the presently running software image.
C3.2 MULTI-P 2
DELETE POINT
Confirm with Enter to execute.
10-16