Technical Specification - JRC JLN-900 Installation And Instruction Manual

2 Technical Specification

Mechanical specification
Height:
Width:
Depth:
Weight:
Electrical specification
Power intake:
Power
consumption:
Display power
output terminals:
ESD power output:
Serial inputs:
Analogue inputs:
Opto inputs:
Serial output
terminals:
Serial terminal:
Analogue outputs:
Switching relay
outputs:
Closing relay
outputs:
Opto outputs:
Ethernet
connection
USB Device
USB Host
Service D-sub
Environmental specification
Enclosure material:
Enclosure protection:
EMC:
Heat dissipation (max)
Colour:
Recommended operating
temperature
Extreme operating temperature:
Extreme operating Humidity:
500 mm + 60 mm under the cabinet for cable glands
500 mm
211.5 mm
19.7 kg
1 100 VAC / 220–230 VAC +/-10% 50-60 Hz
150 VA Maximum, typically 15 VA with 3 pcs SD4 connected
or typically 50 VA with a ESD2 and 3 pcs SD4 connected
9 12..28 VDC-outputs distributed over three fuses:
3 x 1A. Maximum total output load 3A
1 18..32 VDC outputs distributed over one fuse. 1+2 spare terminals
Maximum total output load: 1.5A
9 Standard IEC61162-1 / NMEA0183
1 +/-10 V
4 Digital inputs that can detect a voltage above
3.5 V, maximum voltage 40 VDC
23 IEC61162-1 / NMEA0183, totally 13 drivers
(Divided into 8 channels)
1 RS232 For older generation ESD, in/out
2 +/-5VDC, max load 10 mA
4 Switching: 30VDC / 1A
Note! Not intended for distance pulses.
4 Closing: 50VDC / 0.5A
30V/30mA or 15V/100mA recommended max load when used as
distance pulse relays.
8 5 to 40 VDC, max 50 mA
1 RJ45, DHCP server. Web-interface for service and set up.
1 The USB Device slot is not used.
2 Only the lower USB Host 1 slot is used
1 RS232 for service purpose; terminal, Winflash.
Steel plate
IP22, splash proof
IEC 60945, protected class
= Power consumption
RAL 7035
0°C to +40° C
-15°C to +55° C
Less than 93 % RH (non-condensing) at 40°C
6-6