JRC JLN-900 Installation And Instruction Manual page 124

Example of a menu walk in the R0 REMOTE DEV menu:
R0 REMOTE DEV
CONNECT
press[Enter]
SYNCHRONISING
(counting down from 5)
wait 3 seconds
R1 DEVICE 1 OF 3
BTU 1 (T2A)
press[MENU]
R2 DEVICE 2 OF 3
LPU 1 (LP1)
press[ENTER]
W+XX.X DXXX.X
BL+XX.X T+X.XX
Access to the main menu in the Sig. Distributor. Press
MENU to go deeper into the Sig. Distributor menu system.
To exit back to local mode in the SD4 the ESC button
must be used. The ESC button will always step out of the
remotely controlled menu system.
MENU+ENTER is used to step back within the remotely
controlled menu system.
press[ESC]
R2 DEVICE 2 OF 3
LPU 1 (LP1)
press[ESC or MENU+ENTER]
R0 REMOTE DEV
CONNECT
6-24