Table of Contents
Advertisement
2 Technical Specification
2.1 Performance data
Working principle:
Operating frequencies:
Measuring distance:
Speed Range:
Speed Accuracy:
Distance Accuracy:
2.2 Electrical specification
Input voltage:
Power consumption:
Main Speed output:
Alarm relay outputs:
Serial input:
2.3 User interfaces
LED (external status):
LED (internal status):
Acoustic correlation
Jumping frequencies in the range 3.8 MHz to 4.2 MHz
130 mm from the surface of the transducer.
+/- 50 knots sensed speed
Better than 1% or 0.1 knots relative to sensed water flow
whichever is the greatest
Better than 1%
8V – 15V DC (internal supply from Sig.Processor)
< 30 VA nominal
IEC 61162-1 / NMEA0183. Serial driver RS 422; max load
100 ohm (10 Main displays)
Switching relay, default setting: power failure (30V/2A
recommended max load)
used for PC interface / software update
LED 1 => Log fail alarm inactive,
Led is turned off if log fail alarm activates.
LED 2 => Default settings applied,
LED is turned off if default settings changed.
LED 3 => Signal Quality OK,
LED is turned on if measure exceeds a predefined
quality threshold.
LED 4 => Measuring,
LED toggles for each new speed calculation.
LED 5 => Application alive,
LED toggles each time the watchdog is kicked.
LED 6 => ADC OK,
LED is turned off if LVDS receiver doesn't lock
on incoming data.
LED 7 => Data qualified OK,
LED is turned off if cycle, transmitter and/or
receiver timing don't match (internal SW error).
LED 8 => Data write OK,
LED is turned off if FIFO is full or an internal
error occurred.
LED 9 => Data read OK,
LED is turned off if FIFO overflows.
10-4
Hide quick links:
Advertisement
Chapters
Table of Contents
