Set-Up Of Display; Entering The Menu System; Menu Navigation - JRC JLN-900 Installation And Instruction Manual

5

Set-up of Display

5.1

Entering the Menu system

If the Mode button is pressed for 5 seconds a red text will appear below the push
buttons and the text PRESS ENTER FOR MENU will be displayed in the MODE
WINDOW. Provided Enter is pressed within next 5 seconds, access to the Menu
system is granted, otherwise the MODE WINDOW will return to its previous mode.
When having entered the Menu system and no button is pressed for 3 minutes, the
MODE WINDOW will return to its previous mode as it was before the Menu system
was entered.
5.2

Menu navigation

The Menu system is built up in the same way as in the JLN-900 Speed Logs.
Parameters in the local Display always start with an L, e.g. LP for Local Properties.
The Menu button is used to step to the next menu or input field.
Menu and
input field. Enter is used to go into a submenu and to store changed values.
buttons are used to change values. Esc, or Menu and Enter pressed
simultaneously, is used to step back to a previous/higher submenu level in Local mode.
In REMOTE DEV mode (when Display operates as a remote user interface /"Master
Display") Esc will always break the connection to the remotely controlled equipment
and return to the REMOTE menu R2 therefore only Menu and Enter pressed
simultaneously (and not Esc) shall be used as menu level step-back when navigating
the Menu system in remotely connected equipment.
Information that is possible to change in the Menu by pressing
displayed within brackets [ ] in the MODE WINDOW lower line.
5.2.1 BASIC Menu
This is the start menu when entering the Menu system. It can look different depending
on present settings in the Local Settings Menu.
Typical BASIC Menu with Display, pre-set in Menu LP1.
Typical BASIC Menu if one or more ID for REMOTE DIM is set in Menu LS2,
REMOTE DIM of other Display is displayed. The REMOTE DIM can be set to either
ON, OFF or EXTERNAL.
See chapter 6.3.
pressed simultaneously is used to step back to the previous menu or
SD4-2 LOCAL
SD4-2 LOCAL
REMOTE DIM [OFF]
Remote Dim set-up for more information.
7-10
buttons is