Intended Operation - R&S NGL200 Getting Started

®
R&S NGL200
Prior to switching on the product, it must be ensured that the nominal voltage set-
ting on the product matches the nominal voltage of the AC supply network. If it is
necessary to set a different voltage, the power fuse of the product may have to be
changed accordingly.
4.2

Intended Operation

The instrument is intended only for use by personnel familiar with the potential
risks of measuring electrical quantities.
For safety reasons, the instrument may only be connected to properly installed
wall outlets. Separating the ground is prohibited.
The power plug must be inserted before signal circuits may be connected.
Use only the power cord included in the delivery package. See
package" on page 15.
Before each measurement, measuring cables must be inspected for dam-
age and replaced if necessary. Damaged or worn components can damage
the instrument or cause injury.
The product may be operated only under the operating conditions and in the posi-
tions specified by the manufacturer, without the product's ventilation being
obstructed. If the manufacturer's specifications are not observed, this can result
in electric shock, fire and / or serious personal injury, and in some cases, death.
Applicable local or national safety regulations and rules for the prevention of acci-
dents must be observed in all work performed.
The instrument is designed for use in the following sectors: Industrial, residential,
business and commercial areas and small businesses.
The instrument is designed for indoor use only. Before each measurement, you
need to verify at a known source if the instrument functions properly.
To disconnect from the mains, unplug the IEC socket on the back panel.
See Table 4-1 for the general data on the instrument specification. For more infor-
mation, see the instrument datasheet (PN: 5216.1057.12).
Getting Started 1178.8720.02 ─ 02
Putting into Operation
Intended Operation
"Delivery
13