Table of Contents
Advertisement
Oil pressure sensor
The oil pressure sensor (pressure switch) (1) is located in the front of the oil cooler.
To test the operation of the engine oil pressure sensor (1), proceed as follows.
Use the diagnosis instrument DDS 2 to check that oil pressure in the engine lubrication circuit complies with the
specified values.
If the engine oil pressure value is outside the specified range, check the lubrication circuit components and service
as necessary.
Switch on the instrument panel without starting the engine, disconnect the electrical terminal from the pressure
sensor and connect it to ground:
-
if the warning light does not illuminate, this means the sensor is defective and must be replaced;
-
if the warning light illuminates, start the engine;
-
if the warning light does not turn off, check the DDS 2 system by connecting to connector (A) located in the
electrical components compartment; to reach it, remove the seat.
Hide quick links:
Advertisement
Table of Contents
