Change Coolant - Ducati MULTISTRADA 1200S ABS 2015 Workshop Manual

Change coolant

Warning
Make sure the engine is cold before proceeding. Attempting to change the coolant with the engine hot could lead
to burns from hot coolant or scalding steam.
Remove the LH and RH panel (Removing the panel).
Remove the front half-casing (Removing the front half-casing).
Place a container under the engine and set the motorcycle on its side stand.
Remove the water radiator plug.
Connect a clamp to the expansion reservoir/water radiator pipe.
This is to isolate the expansion reservoir preventing water from flowing out.
Loosen fluid drain plug (1) located on the pump cover.
Allow the coolant to drain off completely.
Screw plug (1) with a new gasket.
Tighten plug (1) to a torque of 19 Nm ± 10%.