All Parameters Measurement; User Defined Parameters - UNI-T UPO2000E Series User Manual

9.3 All Parameters Measurement

Press MEASURE all parameters , select on to measure 34 parameters at one time, as shown below:
Measured parameters colors are consistent with the current channel (source).
When "----" is shown, it indicates that the current source has no signal input, or the measurement result is not valid
(too large or too small).

9.4 User Defined Parameters

Press MEASURE user defined , the user-defined parameter selection interface is displayed. As shown below:
Select the parameters by adjusting the Multipurpose knob, and press the knob to confirm. For every selected parameter,
a * symbol will appear in front of the parameter.
Press the user defined (F3) key to close the user defined parameter selection menu and the parameters will be displayed
at the bottom of the screen. For convenience and immediate view of the automatic measurement results of these parameters,
up to 5 parameters can be defined at the same time.
49