Waveform Recording - UNI-T UPO2000E Series User Manual

Backlight Brightness:
Press UTILITY PgDn
Clear Data:
Press UTILITY PgDn
IP Settings:
Connect the device with a valid network cable, then press UTILITY
IP Type:
Press the type key to switch the IP access mode: manual or automatic.
IP Address:
The format of the IP address is nnn.nnn.nnn.nnn, the range of the first nnn is from 1 to 223, the range of the other three
nnn is from 0 to 255. It is recommended that you consult your network administrator for an available IP address.
Press IP address to enter the IP address setting menu. When the access mode is manual, set the IP address by adjusting
the Multipurpose knob. When the access mode is automatic, you can only view the IP address.
Subnet Mask:
The format of the subnet mask is nnn.nnn.nnn.nnn, the nnn range is from 0 to 255. It is recommended that you consult
your network administrator for an available subnet mask.
Press subnet mask to enter the subnet mask setting menu. When the access mode is manual, set the subnet mask by
adjusting the Multipurpose knob. When the access mode is automatic, you can only view the subnet mask.
RTC Setting:
Press UTILITY PgDn
knob, after the first digit is adjusted, press the Multipurpose knob and the cursor will jump to the second digit, the adjustment
method is similar to the first digit, the latter digit and so on. After all adjustments, press OK to save the settings.

12.2 Waveform Recording

Press UTILITY waveform recording to enter its menu.
Setting:
Press record operation to select setting to make parameter settings for waveform recording.
Recording Interval:
Set the interval between each frame of the waveform recording.
Press the recording interval key and adjust the Multipurpose knob to set.
End Frame:
Press the end frame key and adjust the Multipurpose knob to set an ending frame number that the waveform recording
will automatically stop recording when it reaches this number.
Playback Delay:
Set the interval time between each frame during the waveform playback.
Press playback delay, and adjust the Multipurpose knob to set playback delay.
Maximum Number of Frames:
Displays the maximum number of frames that can be recorded in the current situation (The maximum number of frames
varies based on the current memory depth).
Operate:
Press recording operation, select operate to enter the operation interface.
backlight brightness, and adjust the brightness of the screen by the Multipurpose knob.
clear data to clear the data stored in the device.
RTC setting to enter the date and time setting menu. Adjust the digits by Multipurpose
PgDn IP to enter the IP setting interface.
54