Measuring All Parameters; Measuring Customized Parameters - UNI-T UTD1000L Series User Manual

4.19.1 Measuring All Parameters

To measure automatically all parameters, do the following:
1. Press MEASURE button to display measurement menu;
2. PressF2, then the screen will show measurement results for all parameters.
Note:
1） Switching between different signal sources in UTD1000DL will change the paramteters accordingly for
channels;
2） If the signal is input into only one channel of UTD1000DL, the rise delay, fall delay and phase
parameters will not be measured when this channel is choosen as the signal source; or the signal
source is set to the channel without signal input, no parameter measurement will be made.

4.19.2 Measuring Customized Parameters

To measure customized parameters, do the following:
1. Press MEASURE button to display measurement menu;
2. PressF3, the screen will display measurement paremeters available for your selection;
3. Press Arrow Buttons to select the desired parameters, indicated in different color;
4. Press SELECT button to confirm, the selected parameter will automatically show on the screen. You can
select up to 4 parameters.
5. To turn off the menu, press F3.
Note: For UTD1000DL, use F1 to select signal source to be measured.
24
Figure 4-16 UTD1000L measures all parameters
​ U TD1000L User Manual