Screen Capture Function; Setup] Setting; Parameters Of Measurement - UNI-T UT3500 Series User Manual

this row of data.

4.3 Screen Capture Function

The instrument provides a screen capture function. Insert a USB storage device into the
USB interface on the front panel of the instrument, and press the [OK] key on the panel to
save the current screen capture to the USB storage disk for subsequent reference.
If you need to save data, it is recommended to use a branded U disk to insert the instrument
interface. The format and capacity can refer to FAT, FAT32, EXFAT, and the maximum
capacity is 128G.
When the data is being collected, it may cause the screen capture to fail, which can be
executed after the collection is completed.

5. [Setup] Setting

5.1 Parameters of Measurement

All the settings related to the measurement are operated on the <SETUP> page.
[TRIGGER], [FUNC], [R-RANGE], [V-RANGE] and [SPEED] can also be set on the <TEST>
page. For the setting of these parameters, please refer to chapter 4.1 [Test] Measurement
Page.
The rest of the settings include the following parameters:

AVG - Average number of measurement results

DELAY - Delay before external trigger measurement

SELF-CAL - Whether the instrument executes the calibration routine regularly

CURRENT - Test current output mode
Figure 5-1 <SETUP> Page
28
UT3500 series User Manual