Canon PIXMA Pro9500 Series Quick Start Manual page 75

Problem Possible Cause
Printed Surface is Media is curled
Scratched/Back of
Paper is Smudged
If the paper is curled, it may become marked or not feed properly. Use paper
after correcting paper curl as follows.
When using Photo Paper Plus Semi-gloss, even if the sheet is curled, load one
sheet at a time as it is. If you roll up this paper to flatten, this may cause
cracks on the surface of the paper and reduce the print quality.
1. Place the paper on a flat surface with the print side
with plain regular paper to avoid damaging the surface.
2. Roll up the paper in the opposite direction as shown in the figure below.
(1)
3. Check the printing paper if paper curl is corrected within approximately 2
to 5 mm / 0.08 to 0.2 inches
It is recommended to print the curl-corrected paper one sheet at a time.
Troubleshooting
Try This
*1
(2)
*1
*2
.
face up, then cover it
*1
*2
71