The following paper can be used in the Auto Sheet Feeder.
Standard paper: From 4" x 6" / 101.6 x 152.4 mm to A3+ (13" x 19")
size (329.0 x 483.0 mm / 13 x 19 inches)
Non-standard paper: From 89.0 x 120.0 mm / 3.50 x 4.72 inches to
329.0 x 584.2 mm / 12.95 x 23 inches
From 64 gsm / 17 lb to 105 gsm / 28 lb (plain paper except for
supported Canon genuine media)
*You can use art paper that is not produced by Canon that is up to 200
gsm / 53 lb.
Do not use heavier or lighter paper (except for supported Canon
genuine media), as it could jam in the printer.
See "Non-Canon Genuine Specialty Paper" of the
When printing on plain paper (64 gsm / 17 lb), load up to 150 sheets in
the Auto Sheet Feeder.
However, the paper may not feed correctly depending on the type of
paper and the environment (high temperature / high humidity / low
temperature / low humidity). If this happens, reduce the number of
sheets of paper by about half (approximately 5 mm / 0.2 inches).
When printing on art paper that is not produced by Canon that is up to
200 gsm / 53 lb, load one sheet at a time.
When printing on plain paper, do not stack more than 50 sheets in the
Do not touch the printed surfaces until the ink dries. For specific drying
times, refer to the instructions packaged with your media.