Print Head Cleaning starts when the POWER lamp starts blinking blue.
Do not perform any other operations until the Print Head Cleaning
finishes. This takes about 120 seconds.
(5) Load a sheet of Letter-sized plain paper in the Auto Sheet Feeder.
(6) Confirm the displayed message and click Print Check Pattern to print the nozzle
The nozzle check pattern is printed.
Check the Print Head condition with the printed nozzle check pattern.
"Examining the Nozzle Check Pattern"
If the problem remains after performing Print Head Cleaning twice, try
Print Head Deep Cleaning.
If other than Letter-sized paper is loaded, you cannot print the
nozzle check pattern. Be sure to use Letter-sized plain paper.
Do not perform any other operations until the nozzle check pattern
The nozzle check pattern will not be printed correctly if there is not
enough ink. Replace the ink tank if the remaining amount of ink is
"Replacing an Ink Tank"
"Print Head Deep Cleaning"
(3) Select the ink group to clean.
Clicking Initial Check Items
displays the items to be checked
(4) Click OK.
on page 34.
on page 50.
on page 56.