Load the paper.
If the printer is not used for 5 minutes or more while it is as described in
(1) above, then the FRONT FEED button stops flashing and stays lit and
you cannot set the paper. If this happens, return to (3) in step 4.
When paper is curled, gently bend it in the opposite direction of the
curl (without curling the reverse side) and then load the paper. For
details on how to flatten paper curl, refer to
When using Photo Paper Plus Semi-gloss, even if the sheet is curled, load
one sheet at a time as it is. If you roll up this paper to flatten, this may
cause cracks on the surface of the paper and reduce the print quality.
To prevent paper from being curled, we recommend handling it in the
- Put unused paper back into the package, and store them
- Remove only as many sheets from the package as you need right
For details on how to load the paper, refer to the appropriate section in
"Printing Media" in the
(1) Ensure that the POWER
(2) Load the paper straight
Align the right edge of the
paper against the right side
of the Front Tray.
lamp is lit and the FRONT
FEED button is flashing
If the POWER lamp is
flashing blue, wait until it
into the Front Tray with
the print side facing UP.
Align the front edge of
the paper with the
mark on the Front Tray.
When printing from the
Front Tray, load one sheet
in the Front Tray at a time.
"Media is curled"