Canon PIXMA Pro9500 Series Quick Start Manual page 89

Camera Error Message
Paper Error
Paper jam
Printer cover open
No printhead
Waste tank full /
Ink absorber full
No ink
Possible Cause
The printer is not ready to
feed paper from the Front Tray
yet (Printer ALARM lamp is lit
orange.)
The Front Tray or the Rear
Support is closed (Printer
ALARM lamp flashes orange
three times.)
The Inner Cover is open
(Printer ALARM lamp flashes
orange six times.)
The Front Tray is not set to its
correct position or the Front
Tray was moved during
printing (Printer ALARM lamp
flashes orange ten times.)
The Paper size setting does
not match the size of the
paper loaded in the printer
(Printer ALARM lamp flashes
orange eleven times.)
The paper is not loaded
correctly in the Front Tray
(Printer ALARM lamp flashes
orange twelve times.)
A paper is jammed in the
printer
The Top Cover is open
The Print Head is defective or
not installed
The ink absorber is nearly full For details on how to resolve the error, refer to "Eight flashes"
The ink tank is not installed
properly or empty
Load the paper correctly in the Front Tray according to the
procedure described in "Loading Paper in the Front Tray"
page 9 and press the RESUME/CANCEL button on the printer.
If the Front Tray is closed, open it to resume printing.
If the Rear Support is closed when printing from the Front Tray,
open it and select Continue
* To resume printing, you can press the RESUME/CANCEL
button on the printer instead of selecting Continue.
Close the Inner Cover and select Stop in the display on your
camera to stop printing.
When printing from the Auto Sheet Feeder, return the Front Tray
to its normal printing position. Ensure that paper is loaded in
the Auto Sheet Feeder and then select Continue
on your camera to resume printing.
Refer to "Returning the Front Tray to Its Normal Printing
Position" on page 14 for details about how to return the Front
Tray to its normal printing position.
If you have moved the Front Tray during printing, select Stop in
the display on your camera to stop printing.
Return the Front Tray to the correct position, and try printing
again.
Do not move the Front Tray during printing.
* To resume printing, you can press the RESUME/CANCEL
button on the printer instead of selecting Continue.
Select Stop in the display on your camera to stop printing.
Check the Paper size setting on the PictBridge compatible
device and then load paper that is the same size as the setting
and try printing again.
If this message appears even when the paper loaded is the
same size as the setting, set the printer driver not to detect the
width of the paper.
See "Error Regarding the Width of Paper"
Select Stop in the display on your camera to stop printing.
When printing on 14" x 17" / 355.6 x 431.8 mm paper, load the
paper correctly in the Front Tray according to the procedure
described in "Loading Paper in the Front Tray"
printing again.
Select Stop in the display on your camera to stop printing.
Remove the jammed paper, load new paper, and press the
RESUME/CANCEL button on the printer and try printing again.
Close the Top Cover on the printer.
For details on how to resolve the error, refer to "Five flashes" in
"Handling Error Messages"
in "Handling Error Messages"
Check the number of how many the ALARM lamp flashes and
take the appropriate action to resolve the error.
See "Handling Error Messages"
Troubleshooting
Try This
*
in the display on your camera.
*
in the display
on page 82.
on page 9 and try
on page 76.
on page 76.
on page 76.
on
85