Table of Contents
Advertisement
Set-up
TRADITIONAL METHOD
1. Connect the 54 inch (137cm) length of Air Hose to the metal
tube in the back of each air handpiece.
2. Insert a Male Quick Connect Hose Mount Fitting (P/N 1259-
0087) to the free end of the 54 inch (137cm) length of Air
Hose. Secure the Air Hose to the handpiece power cable with
Cable Clips (P/N 1321-0085-01).
3. Prepare a VisiFilter in the following manner.
a) Connect a 1 inch (2.5cm) length of clear pvc Air Hose to
each side of the VisiFilter; push and turn hose onto
VisiFilter nipple to seat.
b) To the free end of the Air Hose connected to the FLOW IN
side of the VisiFilter, insert the ridged end of a Female Quick
Connect Hose Mount Fitting (P/N 1259-0086).
c) Insert the ridged end of a Male Quick Connect Hose Mount
Fitting (P/N 1259-0087) in the free end of the Air Hose
connected to the FLOW OUT side of the VisiFilter.
d) Connect the VisiFilter Air Hose (with attached male quick
connect hose mount Fitting) to the power source AUTO
SNAP-VAC Port.
4. For vacuum, insert the Male Quick Connect Hose Mount Fitting
connected to the long Air Hose into the Female Fitting on the 1
inch (2.5cm) Air Hose (connected to VisiFilter). For pressure,
insert the Male Quick Connect Hose Mount Fitting directly into
the Controllable PRESSURE Port.
When removing any Air Hose, turn and pull. DO NOT attempt to pull Air Hose
directly off. Damage to or breakage of Vacuum Fitting or VisiFilter may
occur.
CAUTION
Figure 7. Air Hose Connection
Figure 8. VisiFilter Set-Up
20
Advertisement
Table of Contents
