Pace MBT 201 Operation & Maintenance Manual page 23

Set-up
3. Prepare a quick connect Air Hose by inserting
a Metal Hose Clamp (P/N 1211-0036) & a Male
Quick Connect Hose Mount Fitting (P/N 1259-
0087) into each end of a 54 inch (137cm) length
of Air Hose. Push the ridged ends of the
fittings into the hose; slide & twist the metal
hose clamps over the connections to secure.
You may already have this piece if you have
other quick disconnect handpieces configured.
4. Prepare a VisiFilter in the following manner.
a) Connect a 1 inch (2.5cm) length of clear pvc
Air Hose to each side of the VisiFilter; push
and turn hose onto VisiFilter nipple to seat.
b) To the free end of the Air Hose connected to
the FLOW IN side of the VisiFilter, insert the
ridged end of a Female Quick Connect Hose
Mount Fitting (P/N 1259-0086).
c) Insert the ridged end of a Male Quick Connect
Hose Mount Fitting (P/N 1259-0087) in the
free end of the Air Hose connected to the
FLOW OUT side of the VisiFilter.
d) Connect the VisiFilter Air Hose (with
attached Male Quick Connect Hose Mount
Fitting) to the power source AUTO SNAP-
VAC Port.
5. For vacuum, insert the Male Quick Connect Hose Mount Fitting connected to the long Air Hose
into the Female Fitting on the 1 inch (2.5cm) Air Hose (connected to VisiFilter). For pressure,
insert the Male Quick Connect Hose Mount Fitting directly into the Controllable PRESSURE
Port.
When removing any Air Hose, turn and pull. DO NOT attempt to pull Air
Hose directly off. Damage to or breakage of Vacuum Fitting
or VisiFilter may occur.
Figure 6. VisiFilter Set-Up
CAUTION
19