EAS Electric ETH-80VM Installation & Owner's Manual page 192

Use ''▼''、''▲'' to scroll and'' UNLOCK'' to select LOCK or UNLOCK.
The temperature can't be adjusted when the temperature is
locked.The mode can't be changed when the mode is locked. If you
want to change them, you must unlock them use the CHILD LOCK
function.
6.7 Service information
6.7.1 About service information
Service information menu contents as following:
1) service call: to check service call for contacting;
2) error code: to check the error code mean;
3) parameter: to review the operation parameters;
4) display: to set the display.
6.7.2 How to go to service information menu
■ Go to ''MENU'' > ''SERVICE INFORMATION''. Press ''OK'' .
The following page will appear:
■ The service call can show the service phone or mobile nember.The
installer can input the phone number.See FOR SERVICEMAN,
SERVICE INFORMATION
SERVICE ERROR
CALL CODE
PHONE NO. 0000000000000
MOBILE NO. 0000000000000
SCROLL
Error code is used to show when the fault or proction happen and
show the mean of the error code.
SERVICE INFORMATION
SERVICE ERROR
CALL CODE
E2
E2
E2
E2
ENTER SCROLL
OK
Press OK the page will appear:
INFORMATION
■ A total of eight fault codes can be recorded.
SERVICE INFORMATION
SERVICE ERROR
CALL CODE
E2
E2
E2
E2
ENTER SCROLL
OK
PARAMETER DISPLAY
PARAMETER DISPLAY
14:10 01-08-2015
14:00 01-08-2015
13:50 01-08-2015
13:20 01-08-2015
PARAMETER DISPLAY
14:10 01-08-2015
14:00 01-08-2015
13:50 01-08-2015
13:20 01-08-2015
press OK to show the mean of the error code：
12:30 08-08-2015 SAT.
E2 comunication fault between
controller and indoor unit
Please contact your dealer.
CONFIRM
OK
The parameter function is used to display the main parameter, there
are two pages to show the parameter:
SERVICE INFORMATION
SERVICE ERROR
CALL CODE
ROOM SET TEMP.
MAIN SET TEMP.
TANK SET TEMP.
ROOM ACTUAL TEMP.
ENTER
OK
The display function is used to set the interface, the main items is
language,backlight, buzzer and screen lock time:
SERVICE INFORMATION
SERVICE ERROR
CALL CODE
LANGUAGE
BACKLIGHT
BUZZER
SCREEN LOCK TIME
ENTER
OK
Use ''OK'' to enter and use ''◄''、''►''、''▼''、''▲'' to scroll.
Information
Now there is only one language English in the interface.
6.8 Operation Parameter
This menu is for installer or service engineer reviewing the operation
parameter.
■ At home page, go to ''MENU'' > ''OPERATION PARAMETER''.
■ Press ''OK''. There are five pages for the operating parameter as
following. Use ''▼''、''▲'' to scroll.
OPERATION PARAMETER
OPERATE MODE
COMPRESSOR CURRENT
COMPRESSOR FREQUNCY
COMP.RUN TIME1
COMP.RUN TIME2
COMP.RUN TIME3
SCROLL
16
PARAMETER DISPLAY
26ºC
55ºC
55ºC
24ºC
SCROLL
PARAMETER DISPLAY
EN
ON
ON
120SEC
SCROLL
COOL
12A
24Hz
54MIN
65MIN
10MIN
1/5
V.2