2- Install The Exifu - NEC EXIFU-A1 Installation, Configuration And Operation

Install the EXIFU Card

2- Install the EXIFU

! Observe anti-static precautions when handling the EXIFU card.
·
Wear a suitable anti-static strap connected to an Earth point.
One EXIFU card is installed onto the base board within the XN120 main unit.
The EXIFU will be automatically assigned when the system is powered on, after the card is installed.
1 Power off the XN120 system
2 Remove the sub cover and
main cover of the XN120 unit
that will have the card
installed.
3 Fit the EXIFU card.
The card is installed onto the
connector CN2 on the right
side of the base board within
the XN120 main unit.
Ensure the connector is in line
before pushing on the card.
4 Refit the main cover and the
sub cover.
6
You must also power off each XN120 expansion unit if you have any
installed.
Remove the sub cover
Remove the breakouts for the Ethernet/Expansion sockets and the
RS-232 socket before refitting the main cover.
Loosen the 2
screws
Lift off
the
main
cover
Remove the
break outs for
the sockets
XN120 EXIFU Guide