Perkins 904F-E28T Operation And Maintenance Manual page 92

92
Maintenance Section
Fuel System Primary Filter (Water Separator) Element - Replace
Illustration 53
Typical example
3. Install a suitable tube onto drain (2). Open the
drain valve (1). Rotate the drain valve fully
counterclockwise. Two full turns are required.
4. Allow the fuel to drain into the container.
5. Remove the tube from the drain (2).
6. Remove the wiring harness from connection (3).
7. Rotate filter bowl (5) counterclockwise and remove
the filter bowl from assembly.
Note: If a strap wrench is required to loosen the filter
bowl (5), ensure that the strap is positioned in the
middle of the ribbed section. To avoid damage or
mechanical failure, do not position the strap around
the clear area. Do not apply loads to the clear plastic
bowl and the joint of the black plastic section of the
lower bowl.
Illustration 54
g06398147
Typical example
8. Remove the filter element (4). Clean the filter bowl.
Install the New Filter Element
Illustration 55
Typical example
M0125147
g06398170
g06304524