Additional Messages; General Hazard Information - Perkins 904F-E28T Operation And Maintenance Manual

Industrial engine
Table of Contents

Advertisement

8
Safety Section

Additional Messages

The hand high-pressure label is on the high-pressure
fuel line between pump and manifold, on the right
side of the engine.
Ether Warning
Do not use aerosol types of starting aids such as
ether. Such use could result in an explosion and
personal injury.
Illustration 4
Typical example
The ether warning label is installed on the air cleaner
close to the intake. The location will depend on the
application. In some applications, the ether label will
be supplied loose for fitting by the engine installer.
Additional Messages
There are several specific messages on this engine.
The exact location of the messages and the
description of the information are reviewed in this
section. Become familiar with all messages.
Make sure that all the messages are legible. Clean
the messages or replace the messages if you cannot
read the words. Replace the illustrations if the
illustrations are not legible. When you clean the
messages, use a cloth, water, and soap. Do not use
solvent, gasoline, or other harsh chemicals to clean
the messages. Solvents, gasoline, or harsh
chemicals could loosen the adhesive that secures the
messages. Loose adhesive will allow the messages
to fall.
Replace any message that is damaged, or missing. If
a message is attached to a part that is replaced,
install a message on the replacement part. Any
Perkins distributor can provide new messages.
Illustration 5
Purge notice message
This notice should be located next to the battery
disconnect switch.
Do not turn the battery power disconnect switch off
until indicator lamp has turned off. The engine Elec-
tronic Control Module (ECM) is active storing infor-
mation from the engine during this time.
g01154809

General Hazard Information

i08327376
Illustration 6
Attach a "Do Not Operate" warning tag or a similar
warning tag to the start switch or to the controls
before the engine is serviced or before the engine is
repaired. Attach the warning tags to the engine and
to each operator control station. When appropriate,
disconnect the starting controls.
Do not allow unauthorized personnel on the engine,
or around the engine when the engine is being
serviced.
M0125147
g03422039
NOTICE
i08327390
g00104545

Advertisement

Table of Contents
loading

Table of Contents