14. Appendix
14.3 Administrator Login Failure
If you are unable to perform an Administrator login (e.g. because the username/password information has become
corrupted or you have forgotten it), you can clear the login information with the following procedure:
1. Power off the KVM and remove its housing.
2. Short the jumper labeled J29.
3. Power on the switch.
4. When the front panel LEDs flash, power off the switch.
5. Remove the jumper cap from J29.
6. Close the housing and restart the KVM. After restarting, you can use the default login procedure to login (see 9.1
OSD Login).
14.4 Factory Default Hotkeys and Settings
Setting
OSD Hotkey
Invoking HSM Hotkey
Auto Scan Interval
Mouse Emulation
EDID Mode
Beeper
Video DynaSync
J29
Default
[Scroll Lock] [Scroll Lock]
[Number Lock] [-]
5 seconds
Enabled
DisplayPort Monitor's EDID
Enabled
Enabled
63