Table of Contents
Advertisement
7. Installation
7.3 KVM Switch Installation
7.3.1 Single-Stage Installation
To set up the console KVM switch, refer to the following steps and installation diagram.
Note: B024-DPU16 model shown. The port locations are the same for the B024-DPU08, except for the number of KVM ports.
Front
Rear
8
4
2
1
1
Ground the KVM by connecting one end of a grounding wire to the KVM's grounding terminal and the other end
to a suitable grounded object.
Note: Do not omit this step. Proper grounding helps to prevent damage to the unit from power surges and static electricity.
2
Plug your USB keyboard and USB mouse into the unit's USB console ports.
3
Plug your DisplayPort and/or HDMI monitor(s) into the DisplayPort console port, then power on the monitor(s).
4
Plug your speakers into the audio jacks located on the unit's front and rear panel.
Note: The speakers plugged into the front panel have priority over those plugged into the rear panel.
5
Use the provided cable sets (DisplayPort cable, USB 3.0 cable, and audio cable) with this package. Plug the
DisplayPort connector into any available DisplayPort port in the KVM Ports Section of the switch (CPU 1,
CPU 2, etc.), then plug the USB 3.0 cable and audio cable into their corresponding ports.
Notes:
• Verify that all the connectors are in the same KVM Ports Section (all in CPU 1, all in CPU 2.).
• The KVMs only support audio speakers. Do not connect a KVM cable's microphone connector to the speaker ports.
3
4
16
7
6
5
DisplayPort
Cable
Advertisement
Table of Contents
