Components - Tripp Lite NetDirector B024-DPU08 Owner's Manual

5. System Requirements

5.5 Components

Front View
B024-DPU08
B024-DPU16
No. Component
Port Selection
1
Pushbuttons
Port LEDs
2
1 2
1 2
Description
For manual port selection:
• Press a port selection pushbutton for less than two seconds to bring the KVM, USB
hub and audio focus to the computer attached to its corresponding port.
• Press a pushbutton for longer than two seconds to bring the KVM and audio focus to
the computer attached to its corresponding port.
• Press pushbuttons 1 and 2 simultaneously for 2 seconds to perform a keyboard and
mouse reset. See section 10.6 Keyboard / Mouse Reset for details.
• Press pushbuttons 7 and 8 simultaneously for 2 seconds to start Auto Scan Mode.
The Port LEDs are built into the Port Selection Switches. The left ones are the KVM Port
LEDs; the right ones are the USB LEDs:
KVM
• Lights DIM ORANGE to indicate the computer attached to the corresponding port is up
and running (on line).
• Flashes to indicate that Firmware Upgrade mode is in effect.
• Changes to BRIGHT ORANGE to indicate that the computer attached to its
corresponding port is the one that has the KVM focus (selected).
• Flashes to indicate that the computer attached to its corresponding port is being
accessed under Auto Scan mode.
USB
• Lights GREEN to indicate that the computer attached to its corresponding port is the
one that has access to the USB peripherals.
7
4 6 8
3 5 7
4 6 8
3 5 7