Table of Contents
Advertisement
12. RS-232 Operation
12.4.3 Logout
The Logout commands allows you to log out of the KVM and close the RS-232 link.
Use the Formula → to set Parameters → to create a Command.
Formula
Command + [Enter]
Parameters
Command
Logout
Enter
Enter
Logout Command
The formula for the Logout command is as follows:
Command + [Enter]
For example, to logout of the KVM, type the following:
logout [Enter]
12.4.4 Open/Close RS-232 Link
The Open/Close RS-232 Link commands allow you to open and close the link between the computer sending RS-
232 commands and the KVM. When the link is open, the KVM only accepts RS-232 commands and will not respond
to front panel pushbuttons, OSD, hotkeys and remote control commands until the link is closed. The link opens when
you login and closes after 2 minutes if no command is sent.
Use the Formula → to set Parameters → to create a Command.
Formula
Command + [Enter]
Parameters
Command
Open
Close
Enter
Enter
Open/Close RS-232 Link Commands
The available formulas for the Open/Close RS-232 Link commands are as follows:
1. Command + [Enter]
For example, to open the RS-232 link between the computer and KVM, type the following:
open [Enter]
2. Command + [Enter]
For example, to close the RS-232 link between the computer and KVM, type the following:
close [Enter]
Description
Logout command
Description
Enter and send out command
Description
Open RS-232 Link command
Close RS-232 Link command
Description
Enter and send out command
47
Advertisement
Table of Contents
