Fastening The Output Busbars And Pe Terminal And Sliding The Module In - ABB ACS800 Cabinet Installation And Operating Instruction

86

Fastening the output busbars and PE terminal and sliding the module in

The steps of this installation procedure are shown in the photos on the next pages.
1. Connect the output busbars to the pedestal.
2. Fasten the PE terminal.
3. Screw the insulating supports onto the pins on the outer support bracket.
4. Fasten the output busbars and terminals to the insulating supports on the outer
support bracket.
5. Fasten the inner support bracket to the drive module.
6. Remove the fastening brackets (screws "b" on photos under
module to the pedestal
7. Slide the module onto the pedestal so that the inner support bracket enters inside
the outer support bracket.
8. Fasten the outer support bracket to the drive module.
9. Fasten the stickers to the output busbars.
Mechanical installation of non-pre-assembled units (ACS800-04M)
on page 89) from the pedestal.
M6x16
R7
M6x12
R8
Fastening the drive