Mechanical installation of non-pre-assembled units
(ACS800-04M)
What this chapter contains
This chapter describes how to assemble the drive from the assembly kits. First,
before-installation information is given, such as required tools, moving the unit and
checking the delivery. Then, the working order of the mechanical installation is
described. Thereafter, particular assembling instructions follow.
How to read this chapter
Units with bottom exit
1. Read sections
the
2. Go to section
Units with pedestal and busbars on the long side (+H354, bookshelf mounting)
1. Read sections
the
2. Identify your unit by its type code with the help of section
busbars on the long side (+H354, bookshelf mounting)
3. Choose the applying instructions in section
busbars on the long side (+H354)
Units with pedestal and busbars on the short side (+H360, flat mounting)
1. Read sections
the
2. Identify your unit by its type code with the help of section
busbars on the short side (+H360, flat mounting)
3. Choose the applying instructions in section
busbars on the short side (+H360)
Required tools and tightening torques
unit.
Frame size R7 units with bottom exit (+H352)
Required tools and tightening torques
unit.
Required tools and tightening torques
unit.
Mechanical installation of non-pre-assembled units (ACS800-04M)
and
and
Assembling procedure for units with
on page 73.
and
on page 91.
Assembling procedure for units with
on page 104.
Moving and unpacking
on page 49.
Moving and unpacking
Units with pedestal and
on page 57.
Moving and unpacking
Units with pedestal and
45