Assembling The Removable Terminal Block And Housing; Installing The Removable Terminal Block On The Module - Allen-Bradley 1756-CFM User Manual

Assembling the Removable
Terminal Block and Housing
Installing the Removable
Terminal Block on
the Module
1. Align the grooves at the bottom of the housing with the side edges of the
RTB.
Groove
Side edge of the RTB
2. Slide the RTB into the housing until it snaps into place.
WARNING: When you connect or disconnect the removable terminal block
(RTB) with field side power applied, an electrical arc can occur. This could
cause an explosion in hazardous location installations.
Be sure that power is removed or the area is nonhazardous before
proceeding.
Before installing the RTB, make certain:
• field-side wiring of the RTB has been completed.
• the RTB housing is snapped into place on the RTB.
• the RTB housing door is closed.
• the locking tab at the top of the module is unlocked.
1. Align the side, top and bottom RTB guides with the side, top and bottom
module guides.
RTB side guides
Rockwell Automation Publication 1756-UM010C-EN-P - June 2021
Chapter 4 Install the Configurable Flowmeter Module
Groove
Side edge of the RTB
Strain relief area
Module top guide
65