Warning Messages For Damage To Property; Warning: Power Supply Safety; Caution: Wireless Safety; Caution: Product's Surfaces May Become Hot - Eurotech DynaGATE 10-06 User Manual

1 Safety instructions
1.1.2

Warning messages for damage to property

To indicate potential risks of damage to the supported product (or to other property), the following message
is used:
NOTICE
Sign
(if necessary)
1.2

Warning: power supply safety

WARNING
ELECTRIC SHOCK HAZARD
Failure to supply power correctly or to follow all operating instructions correctly, may create an
electric shock hazard, which could result in personal injury or loss of life, and / or damage the
equipment or other property.
To avoid injuries and safely supply power to the product, complete the following steps:
1. Observe all the instructions for safety, installation, and operation
2. Make sure your hands are dry
3. Make sure that all the cables to use:
4. Position cables with care. Do not position cables in places where they may be trampled
or compressed
5. Make sure that the power-points and plugs are in good condition before using them
6. Do not overload the power-points and plugs
7. Make sure that the product maintains a proper grounding connection
8. Use a power supply that meets the product requirements and complies with the relevant
standards and regulations. In case of uncertainties, contact the Eurotech Technical
Support Team (for more information see
page 13)
9. Connect power after the installation of the system has been completed
10. Never connect or disconnect the cables with the system or the external apparatus
switched ON.
1.3

Caution: wireless safety

CAUTION
The antennas used with the product must be installed with care, avoiding any interference with
other electronic devices and keeping a distance from persons greater than 20 cm. If these
requirements cannot be satisfied, the system integrator has to assess the final product with
respect to SAR regulations.
1.4

Caution: product's surfaces may become hot

Depending on the operating environment temperature, product's surfaces may become hot, creating a burn
hazard. Always allow the product's surfaces to cool before touching them.
8 / 72
Text that explains how to avoid damaging the supported product (or other
property)
a. Are in good condition
b. Meet the product requirements and comply with the relevant standards and
regulations
DynaGATE 10-06 User manual Rev. 0-8
"How to receive technical assistance" on