10
Preparation of beverages
10.1 Preparation of coffee
Fill the filter with a dose of ground coffee and
press it with the coffee press;
attach the portafilter to the delivery group;
put the coffee cup under the dispensing spout;
press the desired dose key (e.g. "1 Espresso"
and wait for coffee delivery (all LEDs switch off,
except for that of the selected key).
to stop delivery of coffee in advance, press the de-
livery key again or press the "PROG/STOP" key.
!
Do not remove the filter-holder from the delivery
group during coffee delivery.
10.2 Dispensing hot water
Place the cup under the hot water nozzle;
press the hot water key
of water;
to stop delivery in advance, press the hot water
key again
.
i
When the machine is cool (pressure below 0,6
bar) the dispensing of hot water is not active.
i
To change the temperature of the water deliv-
ered, contact the Technical Support Service.
User manual
)
, wait for the delivery
10.3 Dispensing steam
Immerge the steam nozzle into the bever-
age to be heated and turn the tap knob
counter-clockwise: the steam coming out of the
nozzle will be proportional to the opening of the tap.
To obtain an optimal foaming, it is recommended
to observe the following simple rules:
heat only the amount of milk you intend to use,
once heated, it will have to be completely poured
from the jug and mustn't be heated again;
the milk to be foamed must have a starting tem-
perature of 4°C;
LEAVE THE STEAM NOZZLE IMMERGED IN THE
!
MILK ONLY FOR THE TIME REQUIRED FOR HEAT-
ING. DO NOT OPEN THE STEAM TAP WITH THE
STEAM NOZZLE IMMERGED IN MILK WHILE THE
MACHINE IS OFF.
MILK
41