Configuring Wincc - Siemens SIMATIC FM 458-1 DP User Manual

Connector names
4.9.1.3

Configuring WinCC

Application Module FM 458-1 DP - User Manual
A5E01078222-02 Edition 03.2009
Only the WinCC-relevant information can be taken from the address
book: Data block number and offset of the selected function block
connections.
Function chart name
Function block name
Data block number (DB), offset
When configuring WinCC, proceed in the following steps:
1. Start the WinCC Control Center.
2. Set-up a new project or open an existing one.
3. Set up the new driver by selecting Tag Management  righthand
mouse key  Add New Driver  SIMATIC S7 Protocol Suite.CHN
 Open. If this already exists, then continue with the next step.
4. Set-up a new connection by selecting TCP/IP  righthand mouse key
 New Driver Connection.
Configuring
Data type
4-115