4.8
Parameter access technique for D7-SYS
4.8.1 General description of the parameter functionalityinformation
Hardware
platforms
NOTE
4.8.1.1
Parameters
Application Module FM 458-1 DP - User Manual
A5E01078222-02
Edition 03.2009
By appropriately parameterizing using operator control devices for
parameters at the block I/O:
Reading values
Changing values
Changing values and saving in the CPU change (cache) memory
Changing interconnections using BICO technology
Changing interconnections and saving in the CPU change (cache)
memory
Reading parameter descriptive elements
You can be used for the Parameter access technique following hardware
platforms:
T400 technology module
Application module FM 458-1 DP
SIMADYN D standard CPUs
Masterdrives operator control devices, for example, OP1S or
"DRIVE ES"/"DRIVE Monitor" can be used for parameterization.
When the parameter access technique for D7-SYS you designate block
inputs or outputs as parameter.
There are two types of parameters:
Monitoring parameters
These can be configured at the inputs and outputs of blocks
Values can only be read.
Configuring
4-93