Evaluation Board Hardware; Eval-Adaq4003Fmcz Evaluation Kit; Eval-Sdp-Ch1Z (Sdp-H1) Board; Changes To Figure 2 - Analog Devices EVAL-ADAQ4001FMCZ User Manual

User Guide

EVALUATION BOARD HARDWARE

SETTING UP THE EVAL-ADAQ4001FMCZ AND

EVAL-ADAQ4003FMCZ EVALUATION KIT

Figure 2 shows the simplified block diagram of the
ADAQ4001PMDZ and EVAL-ADAQ4003PMDZ.
26 show the EVAL-ADAQ4001PMDZ and EVAL-ADAQ4003PMDZ
board schematics, which consist of the
ADAQ4003 µModule (U5), the
(U4 and U7), the AD8251 (A1), the
(U2), and the LT3023 (U6). The EVAL-ADAQ4001PMDZ and EVAL-
ADAQ4003PMDZ are flexible designs that enable the user to select
components and operate the evaluation boards from an adjustable
bench top power supply.

EVAL-SDP-CH1Z (SDP-H1) BOARD

The EVAL-ADAQ4001FMCZ and EVAL-ADAQ4003FMCZ evalua-
tion kit uses a serial port interface (SPI) and requires the system
analog.com
EVAL-
Figure 25 to
ADAQ4001 µModule or
ADR4550 (U1), the ADA4898-1
ADP5070 (U3), the LT3032
Figure 2. Simplified Evaluation Board Block Diagram
demonstration platform (SDP-H1) to capture the data via a graphic
user interface (GUI) (see
from a 12 V wall adapter. The SDP-H1 has a Xilinx
and an ADSP-BF527
Figure
a USB 2.0 high speed port.
The SDP-H1 has an FMC low pin count connector with fully differ-
ential low voltage differential signaling (LVDS) and singled-ended,
low voltage, CMOS support. The SDP-H1 also has a 120-pin
connector that exposes the Blackfin
connector provides a configurable serial, parallel I
general-purpose input/output (GPIO) communication lines to the
attached daughter board.
UG-1533
Figure 1). The SDP-H1 requires power
®
processor with connectivity to the PC through
®
processor peripherals. This
2
C and SPI and
Rev. A | 4 of 30
®
Spartan -6