Evaluation Board Hardware; Power Supplies; Default Jumper Setup - Analog Devices EVAL-ADATE304 User Manual

User Guide

EVALUATION BOARD HARDWARE

POWER SUPPLIES

Provide the following external power supplies:
21 V between +21 V DC and GND
►
−10 V between −10 V DC and GND
►
The GND input is provided on the EVAL-ADATE304BBCZ. Each
device supply is decoupled to GND with a 10 μF and 0.1 μF
Table 1. Default Jumper Setup
Jumper Name
VPLUS_ JMPR
VCC_JMPR
VDD_JMPR
VSS_JMPR
SET_RANGE1_JMPR
VTT_JMPR
DUTGND_JMPR
P1
P8
P9
P10
P11
P12
analog.com
Arrow.com.
Downloaded from
Default Function
Inserted Current measurement terminal for VPLUS (0.1 Ω sense resistor)
Inserted Current measurement terminal for VCC (0.1 Ω sense resistor)
Inserted Current measurement terminal for VDD (0.1 Ω sense resistor)
Inserted Current measurement terminal for VSS (0.1 Ω sense resistor)
Inserted Sets the power supply range to Range 1
Inserted Current measurement terminal for VTT (0.1 Ω sense resistor)
Inserted Connects the device DUTGND to AGND plane
Pin 1 to Pin 2 Controls the multiplexers output for read or write bit LED display
Pin 1 to Pin 2 SCLK source select, on-board (default) or external
Pin 1 to Pin 2 SDI source select, on-board (default) or external
Pin 1 to Pin 2 RST source select, on-board (default) or external
Pin 1 to Pin 2 Connects the device SDO to on-board microcontroller
CS source select, on-board (default) or external
Pin 1 to Pin 2
EVAL-ADATE304
capacitor. Each device supply pin is again decoupled with a 0.1
μF capacitor to GND (see the Evaluation Board Schematics and
Artwork section for reference).

DEFAULT JUMPER SETUP

The default setup is for control by the PC through the USB port.
The default link options are listed in Table 1.
Rev. 0 | 6 of 18