Analog Devices EVAL-ADA4352-2EBZ User Manual

General Description

The EVAL-ADA4352-2EBZ is designed to evaluate the
ADA4352-2, a compact,
precision, programmable gain transimpedance amplifier
(PGTIA) that integrates four current-to-voltage gain
selections per channel, in which the gain is programmable
using two logic pins per channel, offered in a 3 mm x 3 mm
x 0.75 mm 16-lead lead frame chip scale package
(LFCSP).
The EVAL-ADA4352-2EBZ is a four-layer printed circuit
board with dimensions of 2.9 in x 2.25 in.
Figure 2 show the board's front and back view. The
evaluation board comes populated with key components
to run and evaluate the board quickly and easily. It also
allots unpopulated resistor/capacitor provisions on its input
and output stages, allowing to install components with
user-defined values for circuits such as a low pass filter or
voltage divider.
The evaluation board is accessible through SMA female
socket edge mounts to directly connect test equipment to
the inputs and outputs of both channels, as well as the gain
switch control pins. It also comes with an unpopulated
photodiode slot on each channel, allowing for quick
prototyping.

Features and Benefits

•
Full featured evaluation board for the ADA4352-2, a
small, dual-channel, complete PGTIA and AFE solution
in a 3 mm x 3 mm 16-lead LFCSP package.
•
Enables quick prototyping.
•
Provision for PGTIA logic control through two-pin
headers or SMA connectors.
•
Provisions for user-defined circuit configuration,
including provisions for photodiodes.
•
Available edge-mounted SMA connectors and test
points to easily connect with test equipment.
Ordering Information appears at end of data sheet.
Rev.0
O n e A n a l o g W a y , W i l m i n g t o n , M A 0 1 8 8 7 - 2 3 5 6 , U . S . A .
monolithic, dual-channel,
Figure 1 and
DOCUMENT FEEDBACK
T e l : 7 8 1 . 3 2 9 . 4 7 0 0
Evaluation Board User Guide
EVAL-ADA4352-2EBZ
User Guide for ADA4342-2 Evaluation Board

Evaluation Board Kit Contents

•
One populated EVAL-ADA4352-2EBZ evaluation
board
•
Six shunt connectors (four usable, two extra)

Document Needed

•
ADA4352-2 data sheet

Equipment Needed

Hardware
•
Digital multimeter (Agilent 34401A)
•
Power supplies (Agilent E3631)
•
Source meter (Keithley 2400) for current source input
•
High precision voltage source (Datel DVC-8500) for
voltage source input
Cables and Components
•
SMA (male) to BNC connector (male) cables
•
BNC connector (female) to dual banana plug adapter
•
Banana to test clip cables
•
SMA 50 Ω termination
© 2 0 2 4 A n a l o g D e v i c e s , I n c . A l l r i g h t s r e s e r v e d .
TECHNICAL SUPPORT