Section 7.2: Install The Glass Stops - Nabco GT1175 Installation Manual

www.NabcoEntrances.com
Rev.5-17-19
1/4-20 x 1"
Phillips Head Screw
Ver cal
Transom
DN 2144
SECTION 7 .2: Install the Glass Stops
Attention: Examples shown within the Glass Stop sections are of the GT1175 Standard Slide Door .
Note: Each Glass Stop is precut at the NABCO Factory according to placement and height of the Transom Vertical.
Note: Glass Panels can be installed before or after the Door Frame is secured to the rough opening.
7 .2 .1 Top of Header
1" Tall, 3/8" Glass
1" Tall, 5/8" Glass
1" Tall, 7/8" Glass
DN 2134
1. Go to the top of Header. Snap-In the Base Glass Stops between each Transom Vertical.
a. Ensure the tall back of Base Glass Stops face the Exterior side of building.
Transom Horizontal
DN 2156
1" Tall, 1/4" Glass
1" Tall, 1/2" Glass
1" Tall, 3/4" Glass
1" Tall, 1" Glass
Base Glass Stop
Figure 11 Install Base Glass Stops on Header between Transom Verticals
GT1175StandardSlideDoorsInstallationManual;withU30Control
#8 x 1"
Pan Head Screw
Figure 9 Secure Transom Vertical to Transom Clip
Header
Example Shown:
Fixed Sidelite
1/4" Glass
Header
Example Shown:
Full Open
Figure 10 Standard Slide Door Snap-In Glass Stops
Transom Ver cal
Measure full width of each Base Glass Stop
Horizontal Transom
Base Glass Stop
Exterior
Base Glass Stop
Exterior
1" Glass
Top of Header
P/NC-00105
Top of Header
9 of 56