Chapter 7: Assemble Door Frame With Transom; Section 7.1: Secure Transom Verticals To Header - Nabco GT1175 Installation Manual

GT1175 Standard Slide Doors Installation Manual; with U30 Control
P/N C-00105
3. Secure the Header to each Jamb Tube with (6) 1/4-20 x .75 Whizlock screws.
a. If installed correctly there will be a 1/8 inch gap between the bottom of Jamb Tubes and the flat surface.
DN 1349
CHAPTER 7: ASSEMBLE DOOR FRAME WITH TRANSOM
Transom Horizontal: Secured between the Header and Rough Opening, plus (2) Jamb Tubes.
X
Transom Vertical: Secured between the top of Header and bottom of the Transom Horizontal. Transom Verticals are
X
X
used to divide glass or panels.
X
Transom Clip used to secure Transom Verticals to top of Header.
X
Glass Stops: Assembly of (2) Brackets with Vinyl Strips. Used to secure glass.
X
X
X
SECTION 7 .1: Secure Transom Verticals to Header
1. Place the Header on a flat surface. Align the Transom clips to the pre-drilled holes on top.
2. Secure Transom Clips to Header with 10 x 1-3/4 inch Phillips Pan Head screws.
a. Please refer to the orientation sticker located on the Header for proper location and orientation.
Orienta on S cker
Top of Header
3. Obtain Transom Verticals.
4. Secure (1) Transom Vertical to each Transom Clip with 1/4-20 x 1" Flat Head screws.
5. Secure the Transom Horizontal onto the Transom Verticals with #8 x 1 inch Pan Head screw.
8 of 56
1/8" gap
Flat Surface
Transom Horizontal
Glass or Panel
Slide Door
Jamb Tube
DN 0688
HEADER COVER SIDE
Header
Figure 6 Secure Jamb Tubes toHeader
1/4-20 x .75" Whizlock Screw
Transom Ver cal
Header
Fixed or Breakout Panel
Ver cal Transom Clip
www.NabcoEntrances.com
Rev 5-17-19
Slick
Jamb Tube
Figure 7 Parts of the Transom
10x1-3/4"
Pan Head Screw
Header Cover
Figure 8 Attach Transom Clips
DN 0419