Section 13.2: Install Bottom Guides; Section 13.3: Adjust Rollers - Nabco GT1175 Installation Manual

www.NabcoEntrances.com
Rev.5-17-19
SECTION 13 .2: Install Bottom Guides
13 .2 .1 Insert Bottom Guide into the Threshold (Full Open Sidelite)
1. Locate the Bottom Guide Assembly that was preinstalled inside the Slide Door Strike Stile.
2. Lift up the Prongs until the Bottom Guide is directly above the Guide Channels. Drop the Prongs into the Guide Channels.
DN 0894
13 .2 .2 Secure the Bottom Guide Double Roller Assembly to the Slide Door (Fixed Sidelite)
1. Go to the Bottom Rail on the Fixed Sidelite. Locate the Bracket that should be sticking out from underneath.
2. Slide the Pivot Stile (on Slide Door) onto the Bracket.
3. Support the weight of the Fixed Sidelite. Breakout the Slide door to Full Open position.
4. Secure the Bracket to the Pivot Stile with (2) 1/4 - 20 x 3/4 inch Whiz-Lock screws.
DN 0640
SECTION 13 .3: Adjust Rollers
13 .3 .1 Hanger Rollers
1. Raise or lower the Slide door by turning the Axle clockwise with a 15/16" Open End Wrench.
a. The appropriate gap between the Bottom Rail and floor is between 11/16 inch to 15/16 inch; with the nominal gap
being 7/8 inch.
2. Ensure the Leading Edge of the Slide door and Header are parallel.
DN 1044
Belt Clip
DN 1702
Guide Channels
Fixed Sidelite
1/4 - 20 x 3/4" Whiz-Lock Screw
Hanger Roller
Hanger Roller Centers must be to the
GT1175StandardSlideDoorsInstallationManual;withU30Control
1/4"-20 x 3/4"
Whiz-Lock Screw
Li Up
Bo om Guide; Prongs
Figure 55 Install Sliding door to Bottom Guide Assembly
Washer
55mm An -Rise Rollers
RIGHT of their bolts.
Figure 53 Secure Belt Clips to Carrier
Figure 54 Drop Prongs into Channel Guides
Slide Door
Hanger Roller
Figure 56 Door Adjustment
P/NC-00105
23 of 56