Section 17.2: Complete The Transom Installation; Section 17.3: Complete The 1/4" Glass Stop Flush Glazing - Nabco GT1175 Installation Manual

GT1175 Standard Slide Doors Installation Manual; with U30 Control
P/N C-00105
SECTION 17 .2: Complete the Transom Installation
Snap-In
Base Glass Stop
Se ng
Block
Snap-In
Base Glass Stop
EXTERIOR
Pocketed
1" Snap-In
Jamb Tube
Glass Stop
Example Shown for Transom Ver cals and Jamb Tubes
1. Place (1) Setting Block (not provided by NABCO) on top of the Base Glass Stops.
2. Place the Glass Panel on top of the Setting Blocks; against the Vinyl. Shift the Glass Panel until it is square.
3. Secure the Glass Panel with Snap-In Glass Stops (Provided by Nabco).
SECTION 17 .3: Complete the 1/4" Glass Stop Flush Glazing
Move Glass Panel Up
1. Place the Glass Panel so it butts up against the Vinyl.
2. Carefully move the Glass Panel UP into the pocket of the Transom Horizontal.
3. Shift the Glass Panel in and out of the pockets until it is square.
a. Pockets within the Transoms are deep enough to allow the Glass Panel to be shifted for proper alignment.
4. Place Setting Blocks onto the Base Glass Stops near Jamb Tubes for proper weight distribution.
28 of 56
Snap-In
Base Glass Stop
Se ng Block
Transom Ver cal
is looking down onto Header
Vinyl
Move Glass
Panel Down
Se ng Block
Snap-In Glass Stop
Glass Panel
Snap-In
Base Glass Stop
Pocketed
Jamb Tube
Vinyl
Se ng Block
Figure 66 Complete the Glass Panel Installation
www.NabcoEntrances.com
Transom Horizontal
EXTERIOR
1" Snap-In Glass Stop
DN 2158
Rev 5-17-19
DN 2147