Section 11.1: Install The Bottom Pivot; Section 11.2: Partially Install The Limit Arm; Section 11.3: Install The Full Open Sidelite Onto The Upper Pivot And Bottom Pivot - Nabco GT1175 Installation Manual

GT1175 Standard Slide Doors Installation Manual; with U30 Control
P/N C-00105
SECTION 11 .1: Install the Bottom Pivot
1. Go to the bottom of the Pivot Jamb Tube. Insert the Bottom Pivot into the hole.
2. Secure the Bottom Pivot to the Pivot Jamb Tube with (1) 1/4-20 x 1/2 inch Phillips Head screw.
3. Go to the screw hole located in front of the Barrel. Secure the Floor Pivot to the Threshold with (1) 1/4-20 x 1/2 inch Phillips
Head Screw.
4. Insert (1) 1/4 x 2-3/4 inch Phillips Head Screw inside the Barrel. Tighten.
5. Cap the Barrel with (1) Bushing.
Bo om Pivot
DN 1045
SECTION 11 .2: Partially Install the Limit Arm
1. Slide (1) .255 ID x .900 OD x .125 THK Nylon Washer onto (1) 1/4-20 x 1 inch Phillips Head Screw.
2. Go underneath the Limit Arm. Insert the Washer and Screw up into the screw hole.
3. Go to the pre-drilled screw hole located at the bottom of Header (on the Pivot Side of Sidelite).
4. Secure the Limit Arm to the Header by tightening the Screw.
a. Loosely tighten (just enough to keep the Screw assembly from falling out of the hole).
b. Limit Arm installation is completed after the Swing Sidelite is fully installed.
Limit Arm
Limit Arm Wheel
DN 0771
SECTION 11 .3: Install the Full Open Sidelite onto the Upper Pivot and Bottom Pivot
1. Locate the Bottom Pivot inside the Pivot Stile (at the bottom). Insert the Bottom Pivot into the Floor Pivot Barrel.
2. Go to the Top Pivot that is preinstalled inside the Pivot Stile. Push the Top Pivot down by pressing on the Spring Pin.
3. Align the Top Pivot with the Pivot Hole located at the bottom of Header.
4. Release the Spring Pin to allow the Top Pivot to snap up into the hole. Ensure the Top Pivot fully engages the hole.
a. If necessary, use a flathead screwdriver to lift up on the Spring pin until the Pivot Pin is fully seated within the hole.
b. Ensure not to pinch Cable Wiring.
18 of 56
1/4-20 x 1/2"
Phillips Head Screw
.255 x .900 x .125 THK
Nylon Washer
1/4-20 x 1"
Phillips Head Screw
Figure 38 Position the Swing Sidelite Panel over the Bottom Pivot at 90° angle
DN 1046
1/4-20 x 1/2"
Phillips Head Screw
Figure 36 Temporarily Secure Bottom Bracket to Jamb Tube
Bo om of Header
Bo om Pivot
www.NabcoEntrances.com
1/4 x 2-3/4"
Tapcon Screw
Figure 37 Partially Install the Limit Arm
Barrel
Rev 5-17-19
Bushing
Pivot Hole