Section 12.2: Install The Bottom Guide Assembly; Section 12.3: Install The Floor Bracket - Nabco GT1175 Installation Manual

www.NabcoEntrances.com
Rev.5-17-19
SECTION 12 .2: Install the Bottom Guide Assembly
1. Go to the bottom of Strike Stile. Remove the Bottom Guide Cover Plate.
2. Install the Bottom Guide Double Roller Assembly by sliding (2) rollers into the Bottom Rail so the Bracket sticks out from
underneath (in direction of where the Slide door is to be installed).
3. Use the Bracket to slide the Bottom Guide Double Roller Assembly towards the Pivot Stile.
4. Replace the Cover Plate.
Bo om Guide Assembly
DN 0865
SECTION 12 .3: Install the Floor Bracket
1. Snap a chalk line between Jamb Tubes in front of Sidelite Panel.
Jamb Tube
DN 0624
2. Go to the bottom of the Strike Stile. Insert the Floor Bracket inside the Bottom Rail so the bottom plate portion sticks out
from underneath (in direction of where the Slide door is to be installed).
3. Close the Slide Door. Adjust the Fixed Panel for weathering gap. Adjust the Slide Door for rocking.
4. Secure the upper plate portion of the Floor Bracket to the side of Strike Stile with (1) 1/4-20 x 1/2 inch Phillips Head screw.
5. Use the Floor Bracket as a template to drill (2) screw holes for #14 x 1-1/4 inch Flathead Tapcon screws.
6. Secure the Floor Bracket to the floor with (2) #14 x 1-1/4 inch Flathead Tapcon screws. Replace the Cover Plate.
Bo om Rail
Strike S le
Floor Bracket
DN 0864
DN 0128
GT1175StandardSlideDoorsInstallationManual;withU30Control
Bo om Guide
Cover Plate
1/4-20 x 3/4"
Phillips Screw
Floor
Figure 47 Slide Bottom Guide Assembly into Bottom Rail
Chalk Line
Fixed Panel
1/4-20x1/2"
Screw
Figure 46 Remove Bottom Guide Cover
Bo om Rail
Jamb Tube
Figure 48 Ensure Fixed Panel is Square
1/4 x 1-1/4"
Figure 49 Install Bottom Bracket
Tapcon Screw
P/NC-00105
21 of 56