Section 7.3: Secure Header And Transom To Pocketed Jamb Tubes; Section 7.4: Assemble Door Frame - Nabco GT1175 Installation Manual

www.NabcoEntrances.com
Rev.5-17-19
Base Glass Stop
DN 2146
SECTION 7 .3: Secure Header and Transom to Pocketed Jamb Tubes
Note: 1175 Slide Door Units installed with a Transom are shipped with Pocket Jamb Tubes only.
DN 0949
1. Place the Header between the Pocket Jamb Tubes so the removable cover side is facing up. Ensure the Frame is still
orientated in relation to the building.
2. Secure the Header to each Jamb Tube with (6) 1/4-20 x .75 Whizlock screws. If installed correctly there will be a 1/8 inch gap
between the bottom of Jamb Tubes and the flat surface.
SECTION 7 .4: Assemble Door Frame
FIXED SIDELITE UNITS:
ACCESS COVER TYPICALLY
FACES THE EXTERIOR
DN 0661
1. Position Jamb Tubes on either side of Header according to the instruction sticker located on each Jamb Tube, showing
proper location and orientation. Ensure the removable cover side of Header is facing up.
Fixed Sidelite: Removable Cover side of Header must face the Exterior side of building.
2. Orientate the Frame in relation to the building:
Full Open: Removable Cover side of Header must face the Interior side of building.
X
X
Vinyl
1/8" gap
Flat Surface
NOTE: Header diagrams shown with Access Cover removed.
Door
Opening
GT1175StandardSlideDoorsInstallationManual;withU30Control
Vinyl
Figure 14 Install Base Glass Stops and Vinyl on Same Side
1/4-20 x .75"
Whizlock Screw
Figure 15 Secure Header to Jamb Tubes
Door
Opening
Figure 16 Orientate the Door Frame in relation to the Building
P/NC-00105
Vinyl
Pocketed
Jamb Tube
FULL OPEN UNITS:
ACCESS COVER TYPICALLY
FACES THE INTERIOR
11 of 56