Chapter 1: Warning Labels; Chapter 2: General Safety Recommendations - Nabco GT1175 Installation Manual

GT1175 Standard Slide Doors Installation Manual; with U30 Control
P/N C-00105
CHAPTER 1: WARNING LABELS
Warning labels are universal and used to alert an individual of potential harm to one's self or to others. The following warning
labels are listed in a hierarchy order that defines the most potential danger first, and the least potential danger last. Please
refer to this page in the event that a warning label is displayed within this manual and further definition needs to be explained.
Indicates potentially dangerous situations . Danger is used when there is a hazardous situation
DANGER
where there is a
property damage unless personal injury risk is present .
Indicates a hazardous situation which has
WARNING
considered for property damage unless personal injury risk is present .
Indicates a hazardous situation which
CAUTION
when there is a possibility of serious injury . Caution should not be considered for property damage
accidents unless a personal injury risk is present .
Attention: A situation where material could be damaged or the function impaired .
Notice: Indicates a statement of company policy as the message relates to the personal safety or protection of
property . Notice should not be used when there is a hazardous situation or personal risk .
Note: Indicates important information that provides further instruction.
CHAPTER 2: GENERAL SAFETY RECOMMENDATIONS
Do not install, operate or service this product unless you have read and understand the General
WARNING WARNING WARNING
Safety Recommendations, Warning Labels, contained in this manual . Failure to do so may result in
bodily injury, or property damage .
Read, study and understand the installation and operating instructions contained in, or referenced
WARNING
in this manual before operating . If you do not understand the instruction, ask a qualified
technician . Failure to do so may result in bodily injury, or property damage and will nullify all
warranties .
Disconnect all power to the junction box prior to making any electrical connections . Failure to
DANGER
do so may result in seriouc personal or fatal injury . When uncertain whether power supply is
disconnected, always verify using a voltmeter .
Do not place finger or uninsulated tools inside the electrical controller . Touching wires or other
DANGER
parts inside the enclosure may cause electrical shock, serious injury or death .
The Ground wire from the U30 Control 120 VAC Harness, and the Incoming 120 VAC Ground wire
CAUTION
must be connected to the Ground screw located within the Swing door Header .
If the door appears broken or does not seem to work correctly, it should be immediately removed
CAUTION
from service until repairs can be carried out or a qualified service technician is contacted for
corrective action .
Notice: This manual, the owner's manual and all other associated manuals must be given to and retained by
the purchasing facility or end user .
Notice: Wiring must meet all local, state, federal or other governing agency codes .
Notice: All electrical troublshooting or service must be performed by qualified electrical technicians and must
comply with all applicable governing agency codes .
4 of 56
probability of severe injury or death . It should not be considered for
high
may result in a minor injury
probability of severe injury . It should not be
some
www.NabcoEntrances.com
Rev 5-17-19
. Caution should not be used