Download Print this page

Fantini Rubinetti ACQUAFIT K001 Manual page 4

Advertisement

PREINSTALLAZIONE
VORINSTALLATION - PREINSTALACIÓN - PRÉ-INSTALAÇÃO
residual current of no more than 30 mA.
- It is mandatory to install a device which allows complete disconnection in overvoltage category III conditions.
This device should be installed on the power supply line, upstream from the device.
Example: main switch (d>3mm) + differential + fuse.
- The electrical connections, the main switch with a differential and fuse, and the control switch must be installed in
compliance with international standard IEC 60364-1.
- The product must only be used with the power supply unit supplied with it.
- The shower head must be connected to the equipotential node in the system, where provided for by international
standard IEC 60364-1. Use yellow/green cable, which should be fixed in the terminal provided and labelled.
- Connection to the water mains must be made using new hoses and piping; do not use old hoses and piping.
- This manual constitutes an integral part of the product. Please store it safely in an accessible place.
- The product is not suitable for use by individuals (including children) with reduced physical, sensory or mental
capabilities, or individuals without the necessary knowledge or experience, unless supervised or instructed on
its use by an individual responsible for their safety. Children should be supervised to make sure that they do
not play with the product.
WARNING: The device can be used by children aged 8 years and above, by people with physical, sen-
-
sory or mental difficulties, or by those lacking experience and knowledge, provided that they are su-
pervised or have been informed as to how to use the device safely and understand the inherent risks.
Children must not play with the device. User cleaning and maintenance must not be carried out by unsuper-
vised children.
- Always take note of all safety warnings and regulations from the relevant bodies in each country.
- In case of a product fault, do not attempt to repair it yourself. Please contact an Authorised Support Centre for original
replacement parts.
- If damaged, to avoid any dangers the power supply cable must be replaced by the manufacturer or a qualified
individual.
- The product does not have components containing mercury or asbestos.
- For cleaning and maintenance refer to the MAINTENANCE chapter, page 61 - 62
CONSIGNES DE SÉCURITÉ : lire avant l'installation et l'utilisation
FR
- Le Fabricant décline toute responsabilité au cas où le produit serait installé dans des locaux avec des
structures et des installations non conformes ou pour des travaux effectués par un personnel ni qua-
lifié ni autorisé.
- L'installation ne doit être effectuée que par un personnel qualifié conformément à toutes les dispositions conte-
nues dans la norme CEI 64-8 (IEC 60364-1).
- L'installateur ne doit pas manipuler les parties électriques ou fonctionnelles du produit, mais se limiter à effectuer
les raccordements et installer les composants comme indiqué dans ce manuel.
- L'appareil doit être raccordé de manière permanente au réseau fixe à travers un dispositif de protection différen-
tiel (RCD) ayant un courant différentiel de fonctionnement nominal ne dépassant pas 30 mA.
- Il est obligatoire de toujours 'installer sur la ligne d'alimentation, en amont de l'appareil, un dispositif permet-
tant la déconnexion complète dans les conditions de la catégorie de surtension III.
Exemple : interrupteur omnipolaire (d>3mm) + différentiel + fusible.
- Le branchement électrique, l'interrupteur général avec différentiel et fusible et l'interrupteur de commande
doivent être positionnés conformément à la norme CEI 64-8.
- L'appareil doit être utilisé seulement avec l'unité d'alimentation fournie.
- Il est obligatoire de raccorder la pomme de douche au nœud équipotentiel de l'installation si prévu par la norme
CEI 64-8 (IEC 60364-1). Utiliser le câble jaune/vert à fixer sur la borne prévue à cet effet et signalé avec l' é tiquette.
- Le raccordement au réseau hydraulique doit être effectué avec des flexibles et des raccords neufs, ne pas utili-
ser de raccords ni de flexibles usés.
- PRE-INSTALLATION - PRÉ-INSTALLATION
4

Advertisement

loading