Region Entrance; Region Exiting - Speco O8FD1 User Manual

5. Set the schedule of the crowd density detection. The setup steps of the schedule are the same as schedule recording setup (See
Schedule Recording).
Note: The camera only can roughly calculate the crowd density through detecting the human faces. The head or back of the person
detected is not counted.
* Configuration of camera and surrounding area
1. The camera lens should face to the people flow. The direction of the people flow is allowed to deviate slightly from the direction
of the camera lens (The angle (a) shall be less than 45°). It is recommended that the angle between the lens of the camera and the
floor (b) shall range from 30° to 60°.
2. The size range of a single person image should take up from 1% to 5% of the entire image and the height range of a single person
image should occupy from 1/5 to 1/2 of the entire image.
3. This function is inapplicable to the scene where there are many moving objects except human shape. (eg. moving cars)
4. A lot of trees and billboards will affect the detection results in the detected area.

4.4.7 Region Entrance

Region Entrance: Alarms will be triggered if the target enters the pre-defined areas.
Go to ConfigEventRegion Entrance interface.
1. Enable region entrance detection and select the snapshot type and the detection target.
2. Set the alarm holding time and alarm trigger options.
3. Set the alarm area of the region entrance detection.
4. Set the schedule of the region entrance detection.
The setup steps of the region entrance detection are the same as the region intrusion detection setup (See Intrusion for details).

4.4.8 Region Exiting

Region Exiting: Alarms will be triggered if the target exits from the pre-defined areas.
Go to ConfigEventRegion Exiting interface.
1. Enable region exiting detection and select the snapshot type and the detection target.
2. Set the alarm holding time and alarm trigger options.
29