Region Entrance - Speco O2P25X User Manual

3. Click the "Save" button to save the settings.
4. Set the alarm area of the intrusion detection. Click the "Area" tab to go to the interface as shown below.
Set the alarm area number on the right side. Up to 4 alarm areas can be added.
Set the detection area by clicking the buttons of area ① and then click "Lock" to lock the area.
Note: The PTZ will not be controlled if you click "Lock" here. Click "Unlock" and then click the buttons of area ① to move the PTZ
camera. Clicking the "Unlock" button suspends object tracking until you click the "Lock" button.
Click the "Draw Area" button and then click around the area where you want to set as the alarm area in the image on the left side
(the alarm area should be a closed area). Click the "Stop Draw" button to stop drawing. Click the "Clear" button to delete the alarm
area. Click the "Save" button to save the settings.
5. Set the schedule of the intrusion detection. The setup steps of the schedule are the same as schedule recording setup (See
Schedule Recording).
※Configuration requirements of camera and surrounding area
1. Auto-focusing function should not be enabled for intrusion detection.
2. Avoid the scenes with many trees or the scenes with various light changes (like many flashing headlights). The ambient brightness
of the scenes shouldn't be too low.
3. Cameras should be mounted at a height of 10ft or above.
4. Keep the mounting angle of the camera at about 45°.
5. The detected objects should not be less than 1% of the entire image and the largest sizes of the detected objects should not be
more than 1/8 of the entire image.
6. Make sure cameras can view objects for at least 2 seconds in the detected area for accurate detection.
7. Adequate light and clear scenery are crucial to intrusion detection.

5.5.4 Region Entrance

Region Entrance: Alarms will be triggered if the target enters the pre-defined areas.
Go to Config Analytics Region Entrance interface as shown below.
31