Subnet Mask - Brother DCP-340CW Network User's Manual
Multi-protocol on-board ethernet multi-function print server and wireless (ieee 802.11b/g) ethernet multi-function print server
Hide thumbs
Also See for DCP-340CW:
- Quick setup manual (43 pages) ,
- Service manual (407 pages) ,
- User manual (112 pages)
Table of Contents
Advertisement
Control panel setup
6
Enter the IP address.
Press OK.
7
Press Stop/Exit.
3.Subnet Mask
This field displays the current subnet mask used by the machine. If you are not using DHCP or BOOTP to
obtain the subnet mask, enter the desired subnet mask. Check with your network administrator for the subnet
mask to use.
(For DCP-340CW)
1
Press Menu.
2
Press
▲
or
▼
to select 3.LAN.
Press Set.
3
(For Wired) Press
▲
(For Wireless) Press
Press Set.
4
Press
▲
or
▼
to select 3.Subnet Mask.
Press Set.
5
Press
or
to select 1 to change.
▲
▼
Press Set.
6
Press
▲
repeatedly to enter the first three-digit number for the Subnet Mask address.
Press Set.
Repeat this step until you have entered the fourth three-digit number to complete the Subnet Mask
address.
Note
Each number can also be increased / decreased by holding down
7
Press Stop/Exit.
or
▼
to select 1.TCP/IP(Wired).
or
to select 2.TCP/IP(WLAN).
▲
▼
▲
or
▼
.
4
4 - 6
Advertisement
Table of Contents
Troubleshooting
