Brother DCP-340CW Network User's Manual page 127

Multi-protocol on-board ethernet multi-function print server and wireless (ieee 802.11b/g) ethernet multi-function print server
Hide thumbs Also See for DCP-340CW:
Table of Contents

Advertisement

Wireless installation for Macintosh
Note
If you choose This PC uses a network cable to
connect to the wireless network., you must configure
the wireless settings from the control panel. Click Next
and follow the on-screen instructions to complete the
setup. When finished, go to the driver installation in step
23.
12
Read the Important Notice.
For DCP-340CW: Press Menu,
6, and choose WLAN. Press Menu. If Reboot OK? is
displayed, press
interface will become inactive with this setting. The
machine will restart automatically. After it restarts,
check the box on the screen and click Next.
For MFC-640CW: Press Menu/Set, 5, 6, and then
press
or
to choose WLAN. Press Menu/Set. If
Reboot OK? is displayed, press 1.Yes. The wired
network interface will become inactive with this
setting. The machine will restart automatically. After
it restarts, check the box on the screen and click
Next.
For MFC-820CW: Press Menu on the control panel. Press
for Network I/F and press OK. Press
press 1 for Yes. The wired network interface will become inactive with this setting. The machine will
restart automatically. After it restarts, check the box on the screen and click Next.
If Accepted is displayed, press Stop/Exit. Check the box and click Next.
Note
It will take approximately one minute for the LAN menu on the LCD to become available after the machine
restarts or is turned on.
®
or
to choose 3,
for Yes. The wired network
for LAN and press OK. Press
or
for WLAN and press OK. If Reboot OK? is displayed,
or
9
or
9 - 5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mfc-640cwMfc-820cw

Table of Contents